Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Search Results

Search Again
  1. Howard_Smith
    Post

    Resume does not switch laser back on

    Thanks Peter My GRBL firmware file has: - $32 = 1 (Laser-mode enable, boolean) The config file has ENABLE_SAFETY_DOOR_INPUT_PIN uncommented...
    Post by: Howard_Smith, Jul 18, 2023 in forum: Control Software
  2. Howard_Smith
    Post

    Resume does not switch laser back on

    Thanks I'm on a PI 4, is that supported now?
    Post by: Howard_Smith, Jul 15, 2023 in forum: Control Software
  3. Howard_Smith
    Post

    Resume does not switch laser back on

    Done lots of reading and can't see where I've gone wrong. Have tried an experiment by disconnecting both A1 and A2, taking the physical lid...
    Post by: Howard_Smith, Jul 15, 2023 in forum: Control Software
  4. Howard_Smith
    Post

    Resume does not switch laser back on

    Hi Peter, or anyone else. Have tried the door sensor but am getting a similar issue. I must be doing something wrong....
    Post by: Howard_Smith, Jul 14, 2023 in forum: Control Software
  5. Howard_Smith
    Post

    Resume does not switch laser back on

    Ah, looks like I have fallen upon the wrong feature. Thanks Peter, will give that a go.
    Post by: Howard_Smith, Jul 10, 2023 in forum: Control Software
  6. Howard_Smith
    Thread

    Resume does not switch laser back on

    I've recently completed a DIY laser cutter specifically for balsa, using a laser diode, GRBL v1.1h and Universal Gcode Sender. The laser is...
    Thread by: Howard_Smith, Jul 10, 2023, 10 replies, in forum: Control Software
Showing results 1 to 6 of 6
Search Again
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice