Separate names with a comma.
Some features disabled for guests. Register Today.
We have the HY01D511B VFD and the manual we have is from the online reseller in china and here is the link since it is 30mb file...
Thanks for the Help, I will go back to it tomorrow and go over all the VFD settings to see if there is anything that will completely stop the...
Yes I tested both boxes M3S0 gives ten volts, M5S0 gives 0.00 volts as expected on both boxes. I tried the PD011 adjustment for 7200rpm for our...
The wiring is exactly the same, the only difference on the black box is the change from a four pin connector to a two pin connector, following the...
Tried this just now, did an eeprom reset, loaded a clean machine changes $30 to 24000 and saved, still with either the turn off spindle or direct...
Tried all the suggestions and still the same issue. At this point we are just going to return these units we purchased (3) and just order the 4x...
I have gone over all the setting regarding signal for spindle and still no joy. I switch the X32 over to the older 4x box and everything works...
We just had to change our blackbox out and the new replacement is the X32. All was good until testing after setting the proper voltage. The...
