Separate names with a comma.
Some features disabled for guests. Register Today.
Great! I’ll give it a shot and see how it works Out. Thanks
So I don’t always have to use the xyz probe?
I created a job in vcarve using the center of my piece as x0, y0. When I go into openbuilds to cut the job I home the machine, probe my stock to...
Sounds great! Thanks, again!
I meant I guess the probe stopped, help lol. I was typing in my phone. I submitted a ticket, I think it’s the wire harness, I’ve required 5 times,...
Guess the help stops
Probe was working but still didnt recognize Z and tried to push through the plate. [ATTACH] [12:04:52] [ $J=G91 G21 X-1000 F8000 ] ok [12:04:52]...
So I got it to flicker triggered in the troubleshooting tab. I redid the wire 4 times going into the plate. The last time I got it work, it...
All connections are tight, no insulation getting clamped, wires are in the clamp and not under. Still nothing, no lights when touching the plate...
Sorry about that, brain fart, jumping it does show it as triggered now.
Shows off no matter what I do.
Tried this, still nothing. Probe still shows.
This is what I have
So ground and signal both in the probe wire slot? Sorry, learning as I go.
Using x-controller that came with the x-carve.
I have custom machine selected because it's an x-carve, is that not correct? I get this when I try to flash. [ATTACH]
I cannot get this thing to work for the life of me. I have an x-carve/x-controller, I ran black to Ground, Blue to Probe, magnet wire is correct...
