Separate names with a comma.
Some features disabled for guests. Register Today.
I have just downloaded ver 1.0.386 of the software. I seem to have a problem the software allows me control of of all three axis I can switch the...
I will Check all connections later this morning
No it wasn't plugged in and just to make sure I reset the interface and the same message appeared on the Screen
Sorry that was an earlier pic try this one still has the same fault. I am clocking off for tonight will come back at it tomorrow
As requested
Yes its 1.58
My interpretation of the instructions. Method One Connect Interface to com port 4 with a USB-C lead this is the port used by the controller. So...
controller is working and connecting to the CNC I have connected the interface with a USB-C lead followed the instructions Click the INTERFACE...
Ok I accept I got it wrong what do i need to do is it a complete reset! of the controller
how do I overcome it Jumper back in run position I followed advice in instruction 3.1.1.6 Extra: Alternative to MODE/RESET Buttons If you are...
I have checked the drivers they are all ok
The instructions on the interface offer three options and like you said I am getting confused between each one. One problem i found this morning...
As I seem unable to reset the controller is there any other way I can access the Flashed drive. I have tried to option of moving the jumper on the...
I have plugged the interface port between Interface Blackbox connector and on the X32 its plugged into the Interface connection. I follow the...
I bought the interface with the Controller with the Black Box 32 over a year ago. I had trouble setting it up so put it aside until I had more...
Thanks for your help
I am using carveco to create my designs
I have the open builds black box controller and i need to enter a dwell command to allow the spindle to reach cutting speed before the program...
Thank you so much silly me. I have been in hospital and have not used the machine for several months. I need to re-acquaint myself with the...
1.2 ohms and 1.3 ohms across the coils checked for isolation between coils seems fine. Disconnected Z powered up the cnc still has the same problem