Separate names with a comma.
Some features disabled for guests. Register Today.
I've tried to invert the SID and GND on my wiring and now it works !!! I'm sorry.
Thank you very much Peter ! You are so reactive.
I checked the wiring with Multimeter. It's good. I will contact Ratrig.
I swap Y and Z, when I test Y on the side it works but not on Z. Btw, y and Z triggered when I start.
Here is the notice: 05. Endstops & Accessories
As the factory choose this one, they should be the same. In the notice, they are all wired the same.
$5=0 Z axis is always triggered $5=7 X and Y axis are always triggered. X and Y axis test is working on troubleshooting, not on Z axis. :/
I have a problem with Z axis inductive limit sensor. It is not triggered when I pass a metalic object like the other does. The 3 sensors have red...
Where can I find the Blackbox port ? I have only one port visible in the connect tab. Yes, it's a BB x32. I have seen in the Grbl pref "grbl...
Strange. I disconnect everything, check all the cable, nothing wrong, restart and now I can use it again. But the problem is I can't use the door...
Hi I tried my CNC with openbuilds control software this morning. It was working fine except the Z axis was inverted and the emergency button was...