Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Search Results

Search Again
  1. Jlcullum
    Post

    Black box controller question

    Hi Peter is it normal for the gains to light up with red ! When turn up did about a 1/4 turn on all then had to dial back down till lights went off?
    Post by: Jlcullum, Dec 26, 2023 in forum: CNC Mills/Routers
  2. Jlcullum
    Thread

    Hole in back of nema motor

    Is it OK to cover dust will get in there
    Thread by: Jlcullum, Nov 5, 2023, 1 replies, in forum: Motors
  3. Jlcullum
    Post

    YL620-A2.2KW 220V & 2.2KW water cooled spindle setup

    Can I run two hot wires and ground through openbuilds power case?
    Post by: Jlcullum, Oct 20, 2023 in forum: Motors
  4. Jlcullum
    Post

    YL620-A2.2KW 220V & 2.2KW water cooled spindle setup

    Ok I can run 220v though openbuilds case instructions only mention flipping switch on power supply. Using the supplied power cord correct?
    Post by: Jlcullum, Oct 20, 2023 in forum: Motors
  5. Jlcullum
    Post

    YL620-A2.2KW 220V & 2.2KW water cooled spindle setup

    Hi I bought the high torque kit from openbuilds was wanting to run power supply with 220v but only 110v cord supplied can I wire that with two...
    Post by: Jlcullum, Oct 20, 2023 in forum: Motors
  6. Jlcullum
    Post

    Huanyang GT series VFD / Blackbox Control

    Did you guys ever figure out wiring blackbox x32 to HUANYANG gt series
    Post by: Jlcullum, Oct 19, 2023 in forum: General Electronics
Showing results 1 to 6 of 6
Search Again
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice