Separate names with a comma.
Some features disabled for guests. Register Today.
Hey all, I do use an old Microsoft Surface hooked up to my OpenBuilds Lead 1010 for using the control software for to control the CNC and also use...
Got another quick question for the group, why does Fusion show machine times much quicker than the OpenBuilds software shows once I start the job?...
Ok - I'll have to try that out!
Ok - ran the job based off of the zero at the hole and it's definitely getting better -- it's weird though the right side is almost perfect, but...
That's pretty much my process other than the Zero at the center of the pin - I'll do a center of the bottom pin (the pin closest to the front of...
Right - this is what I did - set the XY - drilled the holes in the stock and top contour about half the way thru the stock, took it off, drilled...
Ok - tried new zeroing based off of the center of front edge on both sides -- so basically here - then flipped and left the zero exactly the same...
Right on -- I've always zeroed off the bottom left -- so going to try the center zeroing instead and see how things go. Probably going to stop...
Yes I did check the calibration and it's pretty good - pretty much dead on. I did check it over a 600mm span. Yea I guess I could try centering...
Thanks again for all the info - yea on this piece at the top of the post, that's exactly what I did. Didn't use the fixture at all - drew the...
But if I don't change anything about the zero - and it bores the hole at the 3.5" mark, then when I flip it, if I don't touch the zero, it should...
Ok - so in fusion, when I do side 2 (the flipped part) I should re-zero off of the center of the bottom dowel hole? Or should I do that on both...
Ok thanks for the info -- yea, this file is actually much larger since it's a whole guitar and all the parts for it. I did cut the fixture from...
And THANK YOU for any help -- I really appreciate it.
You can see the zero in the first pic on the fixture. when I do the other side, I'm flipping the fixture, but keeping the same X and Y since the...
Hey all, I have an Openbuilds Lead 1010 machine and am using Fusion 360 for this - I’m working on a guitar neck/body and need to be able to flip...
Man, do you guys have a video anywhere or even instructions and how to actually run the Surfacing/Flattening wizard? That would be awesome and I'm...
Ok sweet - thanks for the info. I thought that was already set in there, but I might change it slightly.
Also, is there any way to set the limits on the back end of the machine? My job yesterday ran too far back and was hitting horribly on the back...
Yes sir -- that did the trick!! Crazy and thanks so much. After that, ran the job and the spindle lifted up properly and without issue. I'll...
