Separate names with a comma.
Some features disabled for guests. Register Today.
The IOT says it can handle 12 amps, my router is rated at 6, vac at 8.6, so that is more than it is rated for. No idea what initial amp surge...
Thank you ever so much for clearing that up for me. I'll look into a 2nd IOT as you suggested. Bill P
I read somewhere that a SPDT switch is required when using an IOT relay/spindle/laser configuration. The only reference I see in the documentation...
Got it going!! Turns out that the laser beam was bouncing off the inside of the air nozzle so it wasn't directly focusing on the material. Burned...
$0=10.0 ; Step pulse time, microseconds $1=255 ; Step idle delay, milliseconds $2=0 ; Step pulse invert, mask $3=6 ; Step direction...
Had $30=10000 changed it to $30=4000 which I used on old laser. Tested from Tool On/Off buttons as well as trying to run a previous laser project...
Laser mode is enabled. Laser fires as it should, just doesn't burn. Instructions say to use board if needed.
Installed the laser today. Hooked it up directly to the X32 box and it seems to be working OK, but it doesn't burn anything. I don't think that...
I have a new LaserTree 24V laser on order to add to my custom built CNC. Laser Tree LT-80W-AA-PRO Laser Module I'm using a BlackBox 32...
Worked fine for me. Just make sure you change the port, OpenBuilds uses port 5 whereas Sainsmart uses port 3. I use a BlackBox 32 for my large CNC...
