Separate names with a comma.
Some features disabled for guests. Register Today.
Okay, cool. It seemed like that would be the case. I did notice that in the video, there are no blocks on the underside of the spindle mount. Is...
If I wanted to operate the ring light separately (with it's own wired inline on/off switch), what's the simplest way to just get power? I assume I...
Thank you both! Your assistance and prompt replies to this forum are invaluable. Especially for a neophyte like me.
I also am experiencing some sqeaking/groaning kind of noise when the gantry is moving. I think it's coming from the X axis, but it could also be...
Hello! Okay, so after much trial and error, we have tried what you suggested. We're using a 3/16" single flute in a spiral path for both the...
Yes, you're correct that it's a counterbore. We need a clean flat bottom. We did try doing this with a 1/4" end mill, and it didn't work out as...
I was shooting for the lowest speed I could so the rubber wouldn't melt... at lower speeds, the bottom-cleaning mill would just stop after a peck...
I'd consider making my own dust shoe if the router had survived, but it didn't. I have no idea what caused the meltdown... we haven't put that...
I don't think so... aside from a gooey mess, the rubber sheets we're cutting are way too big, 4' x 2'. I'd have to build a hell of a bath for it....
Okay... so this one may be a bit out of most lanes, but if anyone has any suggestions I'd love some help here. I have a 1515 that we just got set...
Thanks!!
I think there's a typo in your reply... did you mean it won't go over it? (meaning it won't overwrite?) Kinda what I thought, but I just want to...
I haven't asked a stupid question for about a week now, so I'm overdue. Is it okay to load the software using the Wizard onto a thumbdrive that...
Awesome advice. Thank you so much.
As for calibrated... a **** good question! We had someone helping us get set up, and to be honest I don't recall if we did that or not. Chalk that...
First off, I'm super new at this and am only in the beginning stages of wrapping my head around the software. But I have a question that maybe...
Okay, thanks! I just wanted to make sure.
Hello I have a new 1515 that we just got up and running. I'm very new to all this and working on getting up to speed by asking lots of (often...
Okay... I loaded the files and got the probe software working on the Interface now. But does it reside only on the usb? When I take that usb out,...
I tried another endmill, and it worked just fine. (the samd endmill we used previously) so it must be an issue with the other mill. It had been...
