Separate names with a comma.
Some features disabled for guests. Register Today.
I am not using black box. I have an ESP32 controller running GRBLHAL
I have been using the xtension limit switch, but I suspect I have not had it wired properly. I only have 2 wires going in - one to ground and the...
Is there any test procedures I could run thru to verify if it is salvageable?
early in my CNC build I bought a BB32x and think I blew up at one point. I suspect it was due to a bad power supply issue. is there a schematic...
Looking thru the code it looks like pin 21 would support coolant on/off correct? Does the GRBLHal support turning it high/low based on its current...
I have a THC that supports anti dive functionality. While using SheetCam to add post processor rules, thate THC vendor had an example where he...
Any ideas of what would cause that kind of problem? Those two areas were near the end of a 6minute cut. The air pressure was steady the whole...
I ran into a problem on a recent cut using Control where the cut -re-welded itself back together for some reason toward the end of cut. Is there a...
I have been using Fusion 360 with my JD Garage based plasma cutter. I generate the g-code using an openbuilds post processor that works fine. If I...
I have a torch height controller for my plasma table that has an anti-dive (AD) capability. I am using an Arduino Uno R3 to run the GRBL. The THC...
I have had it connected for several months without issue. Would that cause the arduino to not fully load the GRBL? I disconnected the VIN because...
I am getting the following when I start up my Control and try to connect to my plasma machine (JD Garage build). I am running Arduino Uno r3. I...
There are screen shots in my original post that talks about what sheet cam offers
Also if the cut path crosses already cut areas that have dropped out, the THC will plunge the cut head into the open hole to try to maintain the...
It seems cutting small areas can cause the voltage to change if the speed slows down. Tools like Sheetcam can generate gcode that slows down the...
I built a CNC Plasma table that uses OpenBuilds Control software to drive the table. I am adding a THC to my build but the THC references having...
Trying to get the files from my Mac to the Arduino without having to have a USB cable connected. Also considering Bluetooth as an option
After I blew up my BlackBox 32x, I decided to go with a custom Arduino build instead. I have an Arduino Uno Rev 3 that I was able to flash with...
How do you get the power supply out of protection mode?
This seems like a poor design that can be easily fixed. Simple Solutions for Reverse Polarity Protection. when you are providing products for...
