Separate names with a comma.
Some features disabled for guests. Register Today.
you should make sure all your cabling is shielded and grounded.. Eventhough Primeweld Cut60 is blowback start, there is a lot noise in a Plasma...
David, Thank you so much, Success, I have tried a couple of designs that were giving me fits, and this new Post Processor indeed fixes the...
Just updated the cutting tool to 0.06" kerf and 0.5" width, re ran the gcode and got a working file. Not sure this is the final solution,...
Just had a successful gcode file generated. Attached is my fusion file and gcode files So what's different? Going through the Fusion 2D...
Operations- Yes, sorry for the error in description. Changing the Lead in to 0.04" no other changes from the above settings. Well that was...
The file simulates just fine. I did play with the lead in radius, and finally just turned off lead in and lead out completely - see above....
I just created a file that ran w/o error. Not sure this is a fix, as the Top Height and Pierce Clearance aren't right for my set up, but it...
New "official" Arduino made no difference in performance. It was in a sealed box and sure looks like a legit item. I'm going to say, it's...
David, I'm glad you duplicated the error with your setup, maybe we can get to the bottom of this. FWIW- Misterg, I did follow his...
There are several differences between the default 1010 settings and my machine. namely: $3 I have 5 1010 has 4 This sets the direction of...
I took the 1010 default grbl settings and changed them to match what the machine I built calls for. (the file I've posted earlier runs fine...
I am using integers for steps/mm. I need 40 for my machine on X-axis. I was able to get it to run w/o error when I changed the X-axis...
Didn't think about that- I'll see if the "official" R3 works, but I have my doubts that it will change anything
I have a genuine Arduino Uno R3 purchased through Amazon, I suppose it could be counterfeit though ( I also have a Elegoo clone clone that...
Just moved the Arduino over to the Dell laptop. No difference. Log copied and pasted for reference. Still stumped... 09:42:48] [...
I have VER 1.1g.20181112 loaded. I have OpenBuilds Lead 1010 as the machine. I of course edited all the grbl commands to match my machine's...
FWIW- I can cause the error to come and go with the scale factor on the X axis. my machine's scale factor is 40 steps per mm I get an...
Bummer, I reset my machine specific grbl settings and I get the same Error33 in the same location with the same G3 command. But at least I...
OK, I did that, and believe it or not it ran without error. Now I need to put my machine specific numbers back into the grbl settings and see...
Yes, about 2 minutes to run in normal mode and a couple of seconds in Check mode. that is a handy mode by the way
