Separate names with a comma.
Some features disabled for guests. Register Today.
Received and unpacked my 1010 table. 1 of the 4040 linear rails had shipping damage and is unusable. Went to the support site and submitted a...
Much appreciated, I'll remove the M2 and see what happens... the O vs 0 transposition error on my part.
Footer looks like this "M05" "G0 [XH]" "GO [XH] [YH]" "M02"
I use OpenBuilds Control to run my CNC. When operating in anything other than G54 the software defaults to G54 when a toolpath is complete. i.e....
Much appreciated, I have DeskProto on my machine so I'll give it a try.
That is correct.
Using G-CODE WrapY2A(mm)(*.TAP) with Millright UGS for rotary operations without issue. I'm using the Millright controller for the MEGA V XL,...
I'm not using a Blackbox, just the openbuilds control software.
Using v-carve Pro to create the g-code. Post processor is G-CODE WrapY2A(mm)(*.TAP)
Can Openbuilds Control be used for rotary toolpaths. I'm converting from Millrights UGA post processor to Openbuilds Control. First attempt gantry...
As suggested I used the probe wizard. Once again, AWESOME! After going thru the custom setup settings it worked perfectly.
I'm not using Blackbox. MillRight Mega V XL with Mill Right controller and OpenBuilds Control sorfware.
Awesome, changed the code, saved, ran toolpath, Worked perfectly.
Using the following macro to probe for Z using a momentary switch, The macro performs normally until the switch is tripped. When tripped the macro...
Moving from UGS to Open Builds Control. I have G-Code "G4P5" added to my G code for UGS which delays the first rapid movement 5 seconds while the...
