Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks ;)
Hi guys, I want to change the nut on my RoutER11 can I take any type-A nut? I've seen this one on amz Amazon.fr Thank you for your help
I'm kind of ok with you Peter but for sure this probe is dead... The issue is after the wires. In the video you will see that I'm just changing...
First a basic draw on a sheet of paper, then a sketch in illustrator, then some prototypes in fusion 360 and many months later my project is...
I have tried another ground wire but same thing
Hi, My xyz probe was working flawlessly until this afternoon... No led and signal anymore. I think I have checked everything: No loose wire I...
Ok... problem solved... One wire was loose... Thank you peter! Once again you are my hero :)
Thank you Peter. I will check this.
Yesterday I switch on my cnc and tried to jog (as every days). Everything was all right except that the x axe was reversed. Trying to jog a little...
Thank you all for your help. Effectively I was not up to date despite of what I thought. I was on my local but not in the cloud. No post process...
Hi Alex. Here is a pic [ATTACH]
Hi Alex and Peter. Thanks for your help I have the latest version of the postprocess, wcs was set correctly and home was set with a probe. Now...
Hi, I post process my job from fusion and all was allright untill today... Now, when I start the job it goes right in my stock (in Z) and try to...
Hi guys, Can you tell me where is the best place to shim the y axis on a lead 1010? Thanks in advance :)
Thank you! Works great :thumbsup:
I use a 3rd party probe because sometimes I don't have a corner on the jog area to place the probe on. If I flip the probe to grab contact from...
I have the openbuilds xyz probe I have the openbuilds xyz probe but sometimes I just want to 0 my z and and it's easyer with a basic probe....
My bad... Everything is working well :thumbsup: Where could I setup the probe height? Sorry, it is probably another dumb/newbie question. Thank...
Thank you Peter. I have succeed in upgrading to 1.58 flawlessly and I don't have anymore problem on firmware check. But... I can not select the...
Hi guys, My interface is on 1.57 firmware and connected to wifi. When it boots the firmware check is on red and says "unable to check firmware"...
