Separate names with a comma.
Some features disabled for guests. Register Today.
Think just uneven surface and manually holding paper down
Yea no flex. Mounted with clamps. I'll rebuild z to see if I can find a culprit.
Ok attached a pen to frame but honestly I can't tell if good or bad. Did a number of circles in both directions spaced .5 inches apart.
Ok I'll try that putting one on the plate and one on the float and see later.
The z axis is only crappy part of build. In the process of converting mill to CNC then I'll build a better floating z. But for now it's stable and...
Looks like I had to make a yt to upload them as this sight doesn't allow direct uploads. On phone not able to link each one but this is the...
Sorry for delay got caught up working. That was the most extreme case I cut. The slower I cut the worse it is. The faster I cut the better but...
ill take a video later and check areas mentioned. ty. been trying to figure this out every day for the last 7 days at this point ive pretty much...
Ok. X and y are perfectly calibrated. Only like .1 mm off. Cuts are clockwise. It will cut a perfect square. But when cutting a circle y slows...
ok newest update. replaced all couplers from the spirals to the more solid ones with rubber cushion. cleaned every rail again. i have already...
this is just a simple circle i did up to see if it was my gfile but it also cuts the circle the same way as other file this one has smoothing (1...
ive been playing with this for days and ive eliminated 99% possible hardware/gcode issues that i could research as being a possible issue. the...
ok thanks
hi i have been playing with this software for about 2 weeks now on a newly built table and have problems with failed cuts, it probably has to do...
