Separate names with a comma.
Some features disabled for guests. Register Today.
thank you for your replies and the explanation of hardening. along with reducing the RPM's and feed rate, im also monitoring the sound of the cut...
ran the facing pass yesterday again with 15k RPM, 5% stepover and 250mm/min. apparently i was using a 2.5% stepover before. i also used a...
simple 1mm depth spiral cut. although its not accurate for the problem im having since the 1k rpm only switches on the router which normally runs...
it is set to 255 yes. the workpiece is not very big so when it cooperates i can do the facing job in only a few minutes. but lately with this...
i can look into that for sure, but off the top of my head i dont think that would be the case as im using the openbuilds "meanwell" power supply,...
Good Evening. Ive been having an issue lately where the Z axis begins to sink shortly after starting a facing pass. Ive read a lot of discussion...
