Separate names with a comma.
Some features disabled for guests. Register Today.
After doing a mpos homing the arrow direction buttons only work in a positive direction. Before homing the machine will work flawlessly. I tested...
When I enter pos directions it goes positive and when I enter neg it goes negative, until I mpos home. Then all directions are positive. Arduino...
Thanks Alex. I have tried a few times and had no luck. Can you explain how I should go about setting up the directions please. I did some more...
This doesn't sound right to me because the homing direction is correct, it will home towards the switches okay. If I did what you suggest the...
How many ways can limit switches be wired? I have only one switch on each axis, the X and Y trigger on negative end ( lower front left) while the...
That may be so, but there are two homes, one is the wpos home and the other is mpos home. The mpos home is the one that the limits check I believe.
Alex I have the directions working fine, it is a problem with directions after homing. Funny thing is I just loaded into UGS, same wiring, same...
on mine it is lower front left. Homes okay but travels wrong after homing.
Thanks for your input but I don't think it is wiring. I have checked rechecked and checked again and I have made some tests that are playing out...
Okay, I checked all connections and before taking off any stepper motors I thought I would try again. It appears to be a homing problem because I...
Thanks David. I will check all connections again and can swap out the stepper motors and also the boards with spares that I have, to try an...
Thanks Alex. I actually rewired the steppers with heavier cable and tried it out again. I thought I had got it working as it seemed to work in...
I just wired up a new machine and when commissioning it I found a strange problem. I can home no problem. When I move the X axis in a positive...
I am building a new laser engraver/cutter and I have purchased a Two Trees K30 30 watt laser that has crosshair positioning. I use LaserGRBL...
