Separate names with a comma.
Some features disabled for guests. Register Today.
This Thread should be stickied as a great reference to how the x32 works with HY VFD Programming. I say this because I have been through numerous...
My PD070 was the setting I got wrong I have it written in my notes everywhere to set it to 1 and it needed to be set to zero. I have done a lot of...
Awesome post I noticed my PD070 was at 1 and it needed to be at 0 everything I looked at had it at 1 so thats what I went with I have control of...
I did not skip min frequency config why would I do that ? I have my x32 and black box connected exactly like this below which I just saw in...
Paul Relay 1 was the only thing that worked I tried min Frequency and could not start or stop the spindle and as I stated the only way the spindle...
So I ran some more tests ... I tested all the voltages from the x32 to the VFD while connected and they were all pretty spot on with no variances....
Ok Paul so what I have just done is used the relay 1 port COM to DCM ,,,NO to FWD and I am able to start and stop the spindle in the open builds...
Yes the VFD was disconnected and turned off. The XproV5 Issues were across the board every time I got to a step in configuring the Xpro x,y,z,...
Ok so at 100% it was stable at 10v .... at 5% It bounced from 0 to 1 which seems normal ....At 10% it stayed on 0....at 50% it was all over the...
I had $30 at 24000 and changed $31 from 6000 to 0 Same Issue Click but wont turn on What does this mean are these settings i need to change ?>>...
Thats exactly how I had it set PD011 Frequency lower limit set to 100.00 or 6000 rpm I also have it set in Grbl at 6000. I disconnected them...
So everything set up with the x32 and all is working very well limits are good homed the machine all good . Except Spindle control, When I power...
Gotcha thx Peter
Peter I have a quick question Im about to start my install of the x32 black box and interface ...I noticed the black box has an ethernet port .. I...
Im done with the xprov5 they did finally answer me after 8 days with some support documentation but it seemed every single step I took setting up...
So someone else in the thread got help with this (Xpro and HY VFD) and my help is an option to buy a black box ? You might think its a good idea...
I have a few questions obviously many people are having this issue so whats so hard about posting a wiring Diagram from the XproV5 to the HY VFD...
