Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks peter. I did do the calibration, but I followed the video where he adjusted the screw watching the rpm value on the vfd. When I did the...
Hi Peter This is the calibrated file. 24k I got 10.02v after adjustment
Hi Peter the file you asked for
Hi Peter the only thing that is disconnected is the vfd. Everything else is on. bb on vfd disconnected power on (24v power supply) 10% = .78v...
Hi Peter Right, vfd disconnected. Power supply off. bb switched off (rocker on/off switch) = 354mv bb on vfd disconnected power on 10% = .78v...
The wiring , as I said it was only wired to the tool socket originally, then following the video it says use the 2 outside connections because...
Hi Peter No change, these are results; multimeter readings; BBx32. when taking readings, the multimeter probes are on the screws in the plugs....
Thanks Peter. I will do that.
Hi Peter I have re done all the settings and double checked to make sure I have set the vfd to 220. everything is doing as it should now, apart...
All sorted now thank you. $5 was the problem. It kept triggering the z when it was not triggered. I had $5 set to 3 as that was I was given. I...
On the gap after pull off they are measure around 8mm not 10mm. But how does that make one axis not work at all. Today I re wired the z axis...
Perhaps you may see something here Peter.
My $ 44 is 4 - 45 is 3 Is this correct?
Hi Peter I am on 10mm now and now change.
Thanks for the quick reply Peter. I have $27 set to 5mm. X and Y work perfectly. Why not the Z?
Hi all I am using the black box x 32 on my ultimate bee 750x750 and open builds control software Homing all moves in the correct direction. The...
Thanks for the reply Peter Why does it work perfectly ok yesterday and not today?
Hi All I have am issue. I keep getting the red lights coming on and the axis stop moving. From yesterday everything worked fine in terms of...
Hi I have the blackbox x32 on my ultimate bee. When trying to home, the z and the x go the right way but the y goes the wrong way. I keep...
Thanks for the help. I will check the settings. All the steps a correct and measured distances.
