Separate names with a comma.
Some features disabled for guests. Register Today.
Guys: I've run into an unusual problem. I've been using F-Engrave for years, just downloaded the latest version. It is inserting a G90 and a...
Thanks Hugh. This post is actually 4 years old, and the software in question is still in Beta, so that tells you how much they care about their...
That doesn't make much sense. In order to move diagonally, you must activate 2 motors at once. To move in a straight line, you only activate 1...
No, derp, I forgot this was the CBXL. I was thinking of a moving gantry machine like the workbee.o_O If you have any play by moving the router,...
You can get a read on bearing condition In the wheels by loosening the eccentrics right off and spinning the wheel. If the bearing makes noise,...
Could be the Z axis wheels as well. Wheels are difficult to adjust, as Alex says adjust them until you can still turn the wheel with your fingers....
Gage pins, available from Amazon. Handy for lots of things. If you don't need the full set, Mcmaster has precision drill rod in individual sizes....
I use the small PL05N prox sensors available on Ebay etc. I mount a single sensor in the center of the back of the axis plate pointing down...
I've purchased a LOT of stuff from them and have had no issues whatsoever. They are very responsive and answer questions promptly. Just be aware...
Not sure why you would want to do this, what do you make surfboards or something? Just curious: why on earth would you need a 20ft bed? This is...
I agree with Alex on this one. I even think a 1.5Kw spindle is a bit overpowered for these machines. You can buy an 800w water cooled spindle...
Yes, 20mm is a bit much, I always use 6.35mm or 1/4". The only reason it would need to be higher is if you had to clear a clamp or screw head or...
Eddie Probably your best bet is to make two 65x37.5" torsion boxes, with MDF top and bottom. Then join the two boxes together to make your final...
$0 should be left at 10uS. I don't think the Arduino is capable of much shorter pulses than this. $2 may have to be changed to give the correct...
The MSP software communicates by USB, and is completely separate from the motor control inputs. It is certainly possible to monitor the motor...
All of the ground pins for A-, B-, and Enable- must be connected together to your circuit ground. All 3 inputs are isolated, they have no common...
My best advice: RTFM. Everything you need to know is there. It is possible that the SDK motors are pre configured for Step and Direction inputs...
HLFB is a digital output from the motor, not a control input. It can be programmed for several different functions. You can safely ignore it....
As far as I know, he is just using an Arduino. There is no problem hooking up the Arduino to a clearpath motor, it should be a piece of cake....
You would also need to change Laser Mode in the GRBL settings as well. MG
