Separate names with a comma.
Some features disabled for guests. Register Today.
1000 or 1200va, 24v battery pack. a lesser va will do the job, but will not last long (esp the 12v battery ones), and if power goes out for 3...
[MEDIA]
the Mega does not have 10v output, you will have to find a PWM to 0-10v converter and wire it up. unless your VFD can take 5V PWM input directly?
I always use one of the locating pins as x0y0, and table surface as Z0 for the second side, then material thickness no longer matters so long as...
you have missed the 50 or so messages in the forums saying "turn off soft limits' (-: since you have changed some GRBL settings from the...
the limit switch/s is perhaps mounted upside down, or otherwise such that it is connecting power to ground when it is hit, thus causing the BB to...
no binding, did you read the error message? it said 'error 3 reset while in motion', binding will not cause that, but wiring/power supply/EMI...
for plasma, laser mode must be disabled then in Fusion360 you need to enable smoothing and set the value to a useful amount, try kerf width as a...
well you see, it depends..... I am going to assume you mean home, since we usually say 'zero' for where we are going to run a job, which is set...
i woudl mount it with X vertical, and just park it at the bottom before power off so it cannot fall
how did you get to that number? 6:1 gearbox?
never plan layouts until all the stuff is on-site (-:
yes you can connect a probe like this one PGFUN CNC 3D Touch Probe Upgraded XYZ Axis Anti-roll Edge - Want It All then you need to program a macro...
ok, lasergrbl is the problem then, you will have to talk to the experts about that. https://lasergrbl.com/support/ BTW OpenBuildsCONTROL makes...
lets return to this...... so when you run Gcode everything moves correctly, but when you JOG negatives move go positive, right? and this is an...
GRBL has 2 direction settings, one sets the machine directions, which must conform to the cartesian directions for tool motion, X+ is tool right,...
if you touch the magnet to the plate, it should then show as triggered, right? Tha tis how it works, it is a simple switch, connect magnet to...
where is home? industry standard + ends of travel or elsewhere?
check the plugs and sockets on the shield, with the power OFF. dicky connections will probably lead to driver death if you fiddle while they are...
the X4 is a standard Arduino Uno (Atmel 328p) with standard GRBL 1.1 pinout.
