Separate names with a comma.
Some features disabled for guests. Register Today.
Add an indicator for Spindle ON and OFF in the OpebBuilds CONTROL simulator. So when a M3 (clockwise), M4 (counterclockwise), M5 (stop) is...
Thanks
I'm building a specific use machine and intend to use the 20x80 rail for the X and the 40x80 C-Beam for the Y. The previous machine I built for...
I should have mentioned, I just replaced the bushings. In fact, now thinking about it, this didn't occur until after replacing them. I posted a...
Before the Seperator I never had the issue so I had no grounding prior. Now I have a copper wire in the hose through the separator and earth...
Following... Same issues, Lead1010, basic Black box, R11 router. Grounded Dust collection Replaced Brushes in Router Didn't start until adding a...
I'll give that a try.
As stated, already replaced with no change. But what I am more curious about is why one brush in worn 50% more than the other. Is one side of the...
I have suddenly encountered what I believe to be a Static EMI issue. I have been running my 1010 with the same setup w/dust collection for over 2...
Now I keep getting a Alert code 1, Hard limit trigger. happens randomly, nothing hitting the switches. I checked all the cables, look good as far...
I have the LEAD 1010 with the black box and the Interface. This past week I have a couple of Strang things happen. 1 - After running a file I...
Awsome, thanks
I am not understanding something here. Everything has been fine until today. Started the machine, homed all, secured my material, set X , Y, Z...
Yep, did all that. I think I tweaked the current limit up just a bit too much. I brought it back down and so far so good. It hasn't happened...
Yeah I figured it didn't measure the temp on the motors, but if the motor is hot then the driver most likely is also. Might be a short, bad motor,...
UPDATE: Found the info in the manual. Motors are warm but no hot. I adjusted limits back down like they were - Red LED came on for the next 3...
I have a red "!" on my Y1 axes. A reset seems to get rid of it, but wondering if something is going to burn out soon??? This started to happen...
I haven't tried it yet, but "I think" my other Laptop works. I'm pretty sure it is an issue with this laptop. anyways the only reason I was...
USB won't connect. I get an error stating USB device connected malfunctioned and windows does not recognize it. Reinstalled drivers. Any ideas?
nice
