Separate names with a comma.
Some features disabled for guests. Register Today.
I'm curious I noticed with the led ring the pcb gets pretty warm. Are the pcb / parts safe to operate at 24v without some form of heat sinking - I...
yea, once I get the bed leveled I rarely have to re-do it. I've had some fun issues with endstops not being predictable ( hysteresis or other, not...
Mine are fairly stiff but kinda short ( maybe 15mm ). I may swap them out but the m3 lock nuts so far are working great but I do wish I could use...
those are nifty but I've had a heck of a time with non lock nuts loosening over time - do those suffer similar?
Got everything printing over the weekend. I still have a big mess of cables that need cleaning up ( sorry its pretty nasty right now! ) I'm going...
According to apple so yea that would be an awfully long print as well ;) I'm bringing the printer to the local 3d printing meetup tomorrow. I...
My build still has a way to go. Its assembled but likely the Z is a little out of alignment ( guessing its leaning a little to the right - I need...
yea that is part of why I went with this setup vs the original. I put my laptop on the build plate ( likely more heavy than most prints I will be...
Work progresses on my version of the cbot. I'm using a cbeam kit for the Z. Ended up needing the extra large plate ( C-Beam™ Gantry Plate -...
When I print ninjaflex or semiflex I use the following: hotend: e3d v6, .4mm 1.75 hotend temp: 228 bed temp: n/a bed treatment: blue painters...
@ Very much appreciated thanks! Have you printed any flexible stuff with this yet? Looks like it should work fine.
Do you have the titan carriage sources posted anywhere? stl or scad work for me.
which thread? I'm very early in the planning stages for building this bot and was planning to go with the titan extruder direct
I'm curious has anyone tried a cbeam for the Z? Single cbeam center rear was my thinking... Among other things it would reduce the printed parts...
I imagine the 75mm/sec print speed quoted there has more to do with extruder and hotend than mechanical of the frame.
In one of your photos you have a geared stepper in use. By chance what extruder and setup did you run? The motor looks to be a kysan10422X series yes?
What is the approx build area for this setup? Assuming the parts from the openbuilds and panucatt get restocked I think I'll be building one...
