Separate names with a comma.
Some features disabled for guests. Register Today.
We use docs:software:vectric [OpenBuilds Documentation] VCarve is worth it - nothing better for v-carving But DeskProto and Carbide can do it too
You don't even need to get that complicated :) - no need for a hosted setup, nginx nothing. Just Fork the repo, and enable GitHub Pages on it...
Thats the main one - just sit tight!
Orders are still shipping, so not stiffed, just backlogged maybe, or some items not available for shipment just yet - I would recommend just...
I only know of Interface that does all it did, but in essence the UART port on the BlackBox is documented on docs:blackbox-x32:aux-serial...
See https://x.com/OpenBuilds/status/1930611700949975239 - it includes contact details for your enquiry
ttyS0 in the dropdown you selected is probably a onboard serial port on motherboard. Pick the right port: i see ttyUSB in the list. Its a USB device
See - OpenBuilds is winding down and - Why are you going out of business?
No difference in terms of wifi protocols (same chip on board, same antenna, always been 2.4b/g (older protocol, never did support Wifi 6), same...
See the following (near the bottom)
See the details on - OpenBuilds is winding down and - Why are you going out of business? Lots of discussion, lots of links too Machine...
We have the parameters for normal servos here docs:blackbox-x32:connect-rc-servo [OpenBuilds Documentation]
Brand doesn't matter. Electrical specs does. Ideally 3-6v coils, 1.7-3.2A Max current rating, 1-4mH inductance (lower is better) - that would be...
Disable laser mode ($32) when running spindle jobs. Re-enable Laser mode - for laser jobs. See https://github.com/gnea/grbl/wiki/Grbl-v1.1-Laser-Mode
Fault LED lit up after a few mins? docs:blackbox-x32:currentadjustment [OpenBuilds Documentation]
Maybe
Same, just set $6=0 or $6=1 respectively (Use troubleshooting tab to confirm). Just eliminates the possibility of using a touch off and normally...
Simply just flash each device from each correct tab and Indicates the USB port might be worn out or broken - sadly out of warranty by now - but...
Control "connects" to BlackBox. It won't "connect" to Interface. You use either Interface or CONTROL to run your CNC... Don't use the connect...
Good catch! I am running a release for V1.0.390 right now https://github.com/OpenBuilds/OpenBuilds-CONTROL/blob/master/CHANGELOG.txt - removed...
