Separate names with a comma.
Some features disabled for guests. Register Today.
Good afternoon - I've been moving around 10 and 20 inch per minute on the low end. If I take the same patterns and run at 100 to 150 inch per...
If I send manual commands through UGS at a slow feed rate the behavior is the same as the vcarve generated file.
The post processor I've been using is the GRBL (mm). I've also used the G Code post processor and it appears to work as well.
Good morning, - Last night I was able to locate the solder jumpers on the back. I'll dig out my soldering iron and take care of the four axis....
Good Evening, I’m hoping the forum can help because I’ve come up against a roadblock. Some background on setup: - Basic OX design - Four NEMA 23...
