Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks all :) The next big project for my 1010 will be full size doors of Durin. Let's see how big of a thing we can make :)
I have a live edge slab of ash that is 2ft x 4ft that I have been using as a coffee table. I decided to 3d carve a section of the map of middle...
I got my interface bolted onto my 2.7 blackbox and so far I'm really happy. The only thing I'm missing is the ability to add a custom tool...
yeah you nailed that one. I was able to crank it to 6000mm/min before things felt sketchy. Thanks for keeping me grounded :D
I have one of those 4 post steel shelving units holding my 3d printers. It works fine but I wanted to dress it up a bit with some doors. You can't...
I had the exact same issue but it was the green wire in my case. I think I ran the wires a bit too tight on my high z mod 1010 where you...
Does anyone know if it will work with very large gcode files? I'm finding most of the senders that I have available choke when you get much past 2...
Great advice. I jumped to replacing the motors because I have a pair of servos that aren't used, but you are right I've barely tweaked this 1010....
I wrapped my first test job with the lead 1010 today. This is a vectorized version of a block print done by Brian Reedy (Hand-made wood and...
Same situation here coming from an s03 to a 1010. I just hold the probe on my surface. it's 9.10mm on a corner and 12.10 on the surface for my probe
One more tip. for some reason after programming my blackbox for the 1010 using the blackbox programmer, my Z axis was reversed. Opening up the...
I have the mechanicals done so in the event anyone else has a similar question in the future, here are my thoughts. 1. Watch both the 1010...
Hey all, I've been a happy shapeoko 3 user for many years (upgraded over time to aluminum bed, servos, Router 11, custom controller, the list goes...
