Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Acro firmware

Discussion in 'Laser Cutters' started by uverseman, Aug 4, 2023.

  1. uverseman

    uverseman New
    Builder

    Joined:
    Jul 31, 2023
    Messages:
    8
    Likes Received:
    2
    Where can I find the profile for the Acro to load into my x32? I only need XY, no Z.
    I am not comfortable recompiling. I noticed in another post it was told to do it from OpenBuild software, but I cannot find anything other than to flash 2/3 axis without or with door support and 4 axis and custom .bin

    is there an .bin around somewhere for the Acro I can flash? ?
     
    #1 uverseman, Aug 4, 2023
  2. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,435
    Likes Received:
    1,908
    #2 David the swarfer, Aug 4, 2023
  3. uverseman

    uverseman New
    Builder

    Joined:
    Jul 31, 2023
    Messages:
    8
    Likes Received:
    2
    wow thanks a bunch, I did not know about this! It worked..
     
    #3 uverseman, Aug 4, 2023
    David the swarfer likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice