Welcome to Our Community

Some features disabled for guests. Register Today.

Acro Frame not square

Discussion in 'Laser Cutters' started by syl, Feb 15, 2019.

  1. syl

    syl New
    Builder

    Joined:
    Jan 7, 2019
    Messages:
    49
    Likes Received:
    12
    I am building the Acro 510 and it seems my X axis is a little shorter than it is supposed to be. The crazy thing is the main vslot is 1000.. the same size as the front and rear brace.

    Buy when trying to square up the frame the front brace sticks out about 5mm past the Y frame. I will upload pictures in a few hours when I get back home.

    Am I crazy or did I square it up wrong?
     
  2. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Dec 20, 2013
    Messages:
    2,892
    Likes Received:
    1,551
    If you’ll look closely at the images on OpenBuilds ACRO System you can see that the front and rear framing pieces do extend past the Y axis rails.
     
    Peter Van Der Walt likes this.
  3. syl

    syl New
    Builder

    Joined:
    Jan 7, 2019
    Messages:
    49
    Likes Received:
    12

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice