Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Avoiding EMI from Light Ring Wires

Discussion in 'General Talk' started by Rink, Dec 29, 2023.

  1. Rink

    Rink Well-Known
    Builder

    Joined:
    Mar 7, 2020
    Messages:
    160
    Likes Received:
    35
    Good afternoon.
    I want to avoid any potential EMI problems.

    Can I run the Light Ring power cable (24v) in the flex tubing and drag chain along with the motor and limit switch cables? Any EMI concerns with that relatively low voltage?

    Thx, rink
     
    #1 Rink, Dec 29, 2023
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,202
    Likes Received:
    4,346
    Should be fine, no known reports of that being an issue. Just seperate spindle power cable out if possible (swing arm for example)
     
    #2 Peter Van Der Walt, Dec 29, 2023
  3. Rink

    Rink Well-Known
    Builder

    Joined:
    Mar 7, 2020
    Messages:
    160
    Likes Received:
    35
    Yup, got the swing arm installed, it’s holding the router power cable.

    thanks.
     
    #3 Rink, Dec 29, 2023

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice