Hi everyone! For two years a was happy with my killerbee and the old blackbox. But I may have short-circuited the gnd and 1-10v pins of the toolhead output. No I get bearly any voltage from that output or the relay. Do I have any chance of reviving that? Thanks Hans
Sadly not, unless you have board level repair skills and surface mount soldering ability. Rarely economically feasible to pay someone for that, usually cheaper to get a new BlackBox.. Nice thing is for you that's an upgrade to the New X32 so not a total bummer see https://docs.openbuilds.com/blackbox-x32
oh dear... I can solder smd. But I am no expert in diagnosing the defect part. Is it possible to point out the IC oder part on the pcb which might be affected through my stupidity? I'll try to fix it Thank you Peter! Best from Germany!
