I recently did a carve where I set the origin in the near the center of a hollow deep carving. Because I could not lift the bit high enough to clear the surrounding material, I did not want the bit to leave the middle of the carving. The 3D Viewer showed a phantom move to the (0,0) (lower left/bottom) which scared me. I checked the g-code editor (very nice feature, by the way) and searched the beginning and end g-code and did not see this movement. Due the the large size I did not search all of it. I have tried to attach an image below of the job. I successfully ran the job and the movement did not happen, but I found it very disconcerting....
No, it started with: T1 G17 G21 G90 G0Z2.000 G0X350.000Y350.000 M3S19000 G4 P1.8 G0X491.565Y384.661Z2.000 and finished with: G1X492.715Y389.531 G0Z2.000 M5 G0Z2.000 G0X350.000Y350.000 M2 Preview I have put the gcode, VCarve preview and OpenBuildsControl preview in the OneDrive folder above.
