Hi, I am having an issue moving my Blackbox/Workbee machine when using Go To Zero. The machine moves smoothly when jogging along the y-axis(dual motor config) but when I use the Go To Zero command, it gets going for about an inch or 2 and then one of the motors makes a binding noise and the other motor continues until the gantry is out of square and it stops altogether due to the angle. I don't see any motor warning lights when this happens and I've swapped the motor connectors from side to side to no avail. Any ideas on what could be causing this issue?
Either docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation] Or play with the Acceleration and Max Rate settings: gnea/grbl
