BlackBox X32 0-10v Analog Output only outputting 0-1V

I've just built a RatRig Stronghold one 1250 x 1250 and and managed to get the "hello world" example done last night.

I have the AMB CNC Spindle - Digital 1400 FME-P DI 230V 1400Wconnected to the BlackBox X32 controller.

I could only get the spindle to start moving at full speed (output from software) whilst doing the test carve which led me to investigate the 0-10V output which was only outputting 1V with 100% setting from Openbuilds control which would equate to the router running at minimum speed.

When the router was running I had expected it to be more noisy (never having heard it running before), it turns out it was probably running at minimum speed.

Attached ate my Grbl settings. ( i realise the $31 minimum spindle speed is wrong, but that was just me trying things and forgot to return the 3500 correct value)

Hopefully someone can spot an error.

Many thanks for any help.

 

Thanks for your quick reply Peter.

Yes I have reset it and can see the different output selections in Openbuilds control software(and reset the X32)

When adjusting the fine tuning voltage adjustment i can get it up to 1.7V

I even tried $30 at 250000 as i thought it could be a scaling/ division error. I am seeing no difference.

Also, I tried $30 at the default 1000 with the same results. The PWM frequency setting have any beating on the 0-10V output?

 

Thanks again Peter for your reply.

I haven't altered the PWM frequency I don't think. I just read on other threads about the 0-10V being derived from the PWM and wondered if my default was wrong.

I had no issues with the wiring of the 0-10V although i did have problems with the inductive limit switch wiring, ( which are now working perfectly) could my earlier problems with the limit switches have damaged the 0-10V output?

 

sorry, also the 24V is on. I measured with both with the spindle on an off to see it that had any effect.

 

OK Peter have done so. Many thanks for your replies.

 

That's it working!

I think I did alter the $S36 but I must have made an error returning what I thought the previous setting was. Thank you so much for spotting this.

The other settings I am pretty sure I did not alter as I have no clue what they do, but have changed them back to what they should be (as your Grbl file).

When I initially set up my machine I used the workbee defaults (as I thought the ratrig stronghold was a workbee derivative) and had quite a few problems until i found out I should be using the LEAD 1515. Could some of these settings have carried over when I swapped?

Anyway, its working now and I must thank you for your time and effort in resolving this. You really are a legend. ( I was at the stage I thought I had damaged my controller and needed a new one)

Thanks again!