To whom it may concern: Where is the best place to get the complete list of G-code commands for the latest OpenBuilds BlackBox X32 motion controller? Thank you.
The firmware's wikis would be authoritive. As grblHAL is based on grbl, you might need to read both as the grblHAL wiki tends to indicate whats added/improved assuming one is familiar with grbl itself too
Hi Peter, Thank you for your reply. From the grbl wiki (Home · gnea/grbl Wiki (github.com)) I have found the following link: LinuxCNC "G-Code" Quick Reference I am unsure where the grblHAL wiki is situated. Could you assist me? Is this perhaps a page to look at for grblHAL? Changes from grbl 1.1 · grblHAL/core Wiki (github.com) Thank you.
GitHub - grblHAL/core: grblHAL core code and master Wiki but a lot of the other subprojects has additional details too But very first page of the repo (readme) lists a table of supported gcodes too
Thank you, much appreciated. Thanks again for the great controller and CAM software, besides this magnificent controller.
