I recently replaced my original Blackbox with a Blackbox X32. I previously used the 'with door' firmware, and I flashed the 'with door' firmware onto my new Blackbox X32. I use this wireless remote control switch to 'open and close the door' (soft stop). Now when I power everything off, the door opens... I hear the wireless relay click, and when I restart the Blackbox, the door light isn't illuminated. I have to close the door (evidenced by the green door light illuminating), then everything operates normally. Is this a change on the Blackbox X32... is it sending a signal to open the door when it shuts down?
& just a week ago the wireless relay magically remembered to stay on when the power was off. Thanks for the insight.
I'll dig into it & figure out what's happening. I just wanted to check first & see if there was anything different about BBx32, since it's the only thing that I replaced. Having it open the door when powered off seemed like it could've been an on purpose thing, but if it's not sending a signal it can't be that. Thanks..
