Hello, I got the 1515 lead cnc, but I was having trouble looking for the speeds that I should be using for my router11 spindle. I dont believe i saw a speed description in there. also for the spoilerboard, under the wizard there is the option to resurface, etc. but you need to enter the measurements, dose that mean i should measure from the router's center to the home location for both x and y. I got 1300mm and 1150mm,. and if I were to use the 1in surfacing bit, is there a speed form that has a large variety of bits. or some way of calculating the speed you should have for each bit vs material?
docs:tips:router11-rpm-table [OpenBuilds Documentation] For a 1"bit you need the lowest speed your router11 will do. Alex.
I use this as a starting point ( Speeds and feeds) - I tend to use a low speed on my RoutER11 - I have the 220V version so my bottom speed is 13 K rpm - and adjust the feedrate to suit the material. Experiment, but the underlying principle is cutting chips, not making dust. Alex.
