Hello, I have version 2.7 of the black box. I added the 6 pin item and checked the jumper. I loaded four files on the Thumb drive . plugged it it and air cut one of the files, it seemed to perform fine until I tried the about function, It did stop the machine, but would not allow me to resume the cutting. The screen on the interface had two messages in two different colors, One for cancel the other for resume, I could not get either one to do anything,, Please give me some guidance second question with changes made as described to the black box can I remove the cable going to the interface, replace the "computer' cable and run a job that way? Thanks
Is your Interface Firmware up to date? docs:interface:firmware-update [OpenBuilds Documentation] You should be on v1.52 If not, use method 2 or 3 above to update to v1.52
