I'm very new to a lot of this CNC stuff. I just got a DIY kit and I'm not a huge fan of the provided Controller Software. I want to use Open builds and I'm trying to figure out if i can or not. The board I'm using is a Jackpot board with a esp32 from V1E. Any assistance would be appreciated.
Grab a https://docs.openbuilds.com/blackbox-x32 for the best experience CONTROL is mainly meant for our stuff. Tech support for it being exclusive to our customer base. It will connect to most grbl/grblHAL based controllers, but keep in mind if its not ours you are on your own
