Hi! I am thinking to build a machine based on OpenBuilds ACRO System (?) for fast cutting, printed posters, using drag knife The posters are printed on paper 120 mm width, 100 - 150 mm length. The print sizes are always 20*30, 30x40, 35*50, 40*60, 50*70 cm The position of print is always random on sheet. The perfect setup would be • Define the 5 cut presets, easily accessible from OpenBuilds CONTROL • Position the printings sheet under the machine • Position (dragging by hand) the blade at the upper left corner of one print, for example the 40* 50 • Select a the 40*50 cut preset, perform the cut • Position (dragging by hand) the blade at another print, for example the 30* 40 • Select a the 30*40 cut preset, perform the cut... Any input if it possible? If it is, any ideas about the setup? Thanks! Panagiotis
Could use Macros: Getting started with Javascript Macros in CONTROL / Library of Macros created by the community
Dragging by hand is never a good idea. The power generated by the spinning motors will smoke your drivers. Always use the jog function to reposition.
