Welcome to Our Community

Some features disabled for guests. Register Today.

DSP Conversion

Discussion in 'Laser Cutters' started by Robert.sims, Nov 3, 2015.

  1. Robert.sims

    Builder

    Joined:
    Jan 22, 2014
    Messages:
    29
    Likes Received:
    18
    Hi All
    I hope someone out there can help me please.
    I am building a laser cutter/engraver based on the Bdring model with maker slides and v slot rollers.
    I have had this working with
    New DSP CO2 Laser Cutter Engraver Machine LCD Motion Controller System PH3
    New DSP CO2 Laser Cutter Engraver Machine LCD Motion Controller System PH3 | eBay

    I am trying to set up this board but I am not having much luck.
    If I switch on the machine the x and the y axis go to the home postion fine.
    but if I try to move the zxis with the arrow buttons on the machine or the software I somtimes get a jerk then nothing.or I get no movement at all.
    I am trying to setup the parameters but with no luck I came across this page

    dsp:dsp_controller [Buildlog.net Wiki]

    but the file that is mentioned there will not load into the progamme.
    Can anyone help please.

    Bob
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice