Hey all, Hope you guys are doing great. Quick question guys. I was running my mill and it stopped all of a sudden. Error 9 came out, asked me to rehome it. I rehomed it and set it back at my zero. Ran it again and the same thing came out. Then I messed up and didnt rehome it and just ran the job. It dug into the wood and blew my breaker (whoops -_-) I rehomed it and did the zeroing again. and Its still stopping the job like 4-10 min into the job. Im I doing something wrong? Thank you guys
v1.0.276 will fix a bug so - you can just hit Enter it will go away - it should as a safety measure lock out jogging until you close the message - its not childish to keep people safe, however, the bug in v1.0.275 means you are not getting the full experience of what its supposed to be like. v1.0.276 should be out later this week
You may hate it, but some people requested it. It is helpful for those that charge for their services by the hour. The first time I noticed it was last night, and I found it useful to compare that to what the stated time in Vectric Vcarve would be.
I can see it both ways... It should be an option to have it displayed. post it off to the side in its own display on the screen per job. It does popup a min or two before the job is even done. I am having same message every time I try to tram my router. Not sure what worse the random ALARM: 1 / error:9 or the popup stating its done before its done.
