Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Error running Fusion 360 1001nc

Discussion in 'CAM' started by wvarn1957, Sep 5, 2020.

  1. wvarn1957

    wvarn1957 New
    Builder

    Joined:
    Mar 14, 2015
    Messages:
    1
    Likes Received:
    0
    When I try to run a Fusion 360 generated 1001nc in open builds control I get the following error message: g code words consist of a lertter and a value. Letter was not found [:(PGM, NAME="1001")]. I am relatively new to this so I am not sure how to correct this.Any help would be greatly appreciated
     
    #1 wvarn1957, Sep 5, 2020
  2. Alex Chambers

    Alex Chambers Master
    Moderator Builder

    Joined:
    Nov 1, 2018
    Messages:
    2,783
    Likes Received:
    1,364
    What post processor are you using?
    Alex.
     
    #2 Alex Chambers, Sep 5, 2020
  3. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,046
    Likes Received:
    4,313
    #3 Peter Van Der Walt, Sep 5, 2020

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice