Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Hooking up the Interface.

Discussion in 'Interfaces' started by Richard Gallatin, Feb 20, 2022.

  1. Richard Gallatin

    Richard Gallatin New
    Builder

    Joined:
    May 17, 2021
    Messages:
    16
    Likes Received:
    1
    I have a Millright CNC i am trying to use the Blackbox and Interface with. My machine works with the Openbuilds Software and the Blackbox. I have updated the firmware with no issues. When I plug in the Interface and turn everything on my Interface does all the test and show OK. When that is done it restarts and does not seem to load my GRBL settings. I am guessing that the Blackbox and Interface needs to be plugged into my computer and the flash drive into the interface.
     
    #1 Richard Gallatin, Feb 20, 2022
  2. Richard Gallatin

    Richard Gallatin New
    Builder

    Joined:
    May 17, 2021
    Messages:
    16
    Likes Received:
    1
    OK I figured it out. I had my Blackbox plugged into computer with USB I did not need to do that.
     
    #2 Richard Gallatin, Feb 20, 2022
    Peter Van Der Walt likes this.
  3. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,191
    Likes Received:
    4,346
    Correct. Either USB or Aux, both cannot be active at the same time
     
    #3 Peter Van Der Walt, Feb 20, 2022

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice