Welcome to Our Community

Some features disabled for guests. Register Today.

How much longer should the lead screw be (C-Beam)?

Discussion in 'General Talk' started by rlrhett, Oct 18, 2017.

  1. rlrhett

    rlrhett New
    Builder

    Joined:
    Oct 7, 2017
    Messages:
    26
    Likes Received:
    0
    When putting together a lead screw C-Beam actuator, how much longer must the screw be than the actual aluminum extrusion. I assume the screw must be = (length of extrusion) + 2(end plates) + ????. How far must the screw extend past the end plates for a coupler to grab it at one end and and a lock collar on the other?

    I see that both the extrusion and the screws are sold the same length, and I assume I will need to trim back the extrusion.

    Thanks,
     
  2. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Dec 20, 2013
    Messages:
    2,898
    Likes Received:
    1,556
    Ref. note at bottom of 8mm Metric Acme Lead Screw. Actual length is 40mm longer than stated length which is sufficient for standard connections.
     
    CiaraB likes this.
  3. rlrhett

    rlrhett New
    Builder

    Joined:
    Oct 7, 2017
    Messages:
    26
    Likes Received:
    0
    Thanks!!!
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice