I've been searching the threads for some info and I'm having trouble finding some good info to start with. I'm trying to figure out what microstep setting to use. I can go down to 1/32 step, should I? This is the controller I have. Arduino CNC Shield – 100% GRBL Compatable | Protoneer.co.nz Should all three axis use the same microstepping? Is it possible to flip the Y axis C-Beam so the motor is in the front? This will help me for placement of the machine up against a wall. Is there a reason the table is limited to 12x12 when it looks like there is quite a bit of clearance from the sides. My thoughts are to install threaded inserts on the sides/front/back for hold down clamps. Does anyone know where to buy a 1/8" collet for a Dewalt 611 router. All I can find is a sleeve adapter. Thanks!
First you want microstepping at 8x. I have the same setup. Y-Axis can go either way far as I can tell. As for inserts check out a company called The Elaire Corporation Make sure to order for Palm style router. The others are to big. Mike
