Welcome to Our Community

Some features disabled for guests. Register Today.

Interface issues update

Discussion in 'Control Software' started by philou, Mar 2, 2021.

  1. philou

    philou New
    Builder

    Joined:
    Jan 15, 2021
    Messages:
    3
    Likes Received:
    0
    Hello,

    after the latest software update we can not any more plug the interface and the computer to pilote the CNC, it's an issue because you can't run probe with the right diameter setting. is it normal

    thanks
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,507
    Likes Received:
    4,422
    Control Update didnt touch that section at all. Reboot PC and Interface, try again
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice