tinyg and cnc has been working fine for about 2 weeks. Then today started to cust some simple work. Then 5 minutes it just stops moving. Since I was using chilipeppr I thought a network issue. But with a direct connection it did it repeatly. Some times 5 minutes, others 20 minutes. Then I noticed the SPDR light next to the powerlight flashes. It locks all control of the board. Only way to reset is to power cycle. Any ideas? Bad tinyg?
After hours of hitting a dead in I figured out one of the switches was malfunctng and triggering a fault. I turned off the homing switches and limit switch and resolved the issues. I ran about 10 more 30+ minute cutting jobs and worked perfectly now.
