My workbee 1010 keeps stopping and flashing the alert but no message pops up. Attached is the picture of the code when this happens. I have tried new usb cables and different computer, updating, restarting, tracing all wires and checking connections.
That indicates the controller reset itself. Running any 3rd party parts like a VFD spindle? Or anything else that's nonstandard?
Check that USB selective suspend is off (sometimes a windows update can re-enable it): docs:blackbox:install-windows-selective-suspend [OpenBuilds Documentation] Also check if the same happens with the Router turned off (zero high, run a job "in the air" with the router off). If the Dewalt is approaching 3 years too its brushes may be worn leading to sparking causing EMI. Quick test run without the router will show you if its related
