Welcome to Our Community

Some features disabled for guests. Register Today.

Lead 1010 Max speed for cutting foam board

Discussion in 'CNC Mills/Routers' started by BillyTheClown, Jun 5, 2024.

  1. BillyTheClown

    Builder

    Joined:
    May 30, 2024
    Messages:
    16
    Likes Received:
    7
    Just upgraded to Lead 1010 with high-z, expect to do my first cut tonight or maybe tomorrow night...

    On my old (slow) CNC I use cheap Home Depot pink foam insulation board for test cuts.

    I set the system MAX Feed/Plunge speeds in my Aspire tool path for the test cuts, and usually just do the finish pass skipping the roughing pass.

    What is the max feed speed for the lead 1010? Plunge speed?
    Looking at the doc but unable to find the values.

    Thanks..... Billy
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,917
    Likes Received:
    4,291
    Click Grbl Settings tab: see $110-112 Grbl v1.1 Configuration
     
  3. BillyTheClown

    Builder

    Joined:
    May 30, 2024
    Messages:
    16
    Likes Received:
    7
    Peter, Thank you...

    Need to start reading Grbl settings..... Still a lot to learn..
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice