Hi all, I have been running my machine for quite a while now. I have never had issues with my limit switches. But all of the sudden when I went to use it today, two of the three limit switches where constantly seen as "triggered" by the Blackbox controller. Please notice the following: I have not changed any wiring, the switches has worked for like 6 months with no issue I have tried turning off the computer I have tried fully unplugging the Blackbox controller (to remove power completely) I have tried the reset button (not sure exactly how that is supposed to work) I have tested the switches by moving the axis close enough to see the diodes turn on and then off when moved away again. I have tried unplugging the switches I have checked the wires, they are fine The x-axis switch works just fine As far as I can tell. The rest works fine. If anyone has seen this before, please advice. Cheers Martin
Reset =restarts the firmware. Reboot. If they still show triggered even if unplugged, something damaged the Blackbox ports. Any miswirings, surges, etc you know about? Contact the store via https://support openbuilds.com > New Ticket. Any info of event around the limits that could have caused damage might just help with advice, so do let them know if you think of anything
i am now having the same issue on my X32 Black Box X axis. is the masking in the firmware correct or could i manipulate it to reverse the input
