Hello. Recently i bought quenbe CNC machine with blackbox controller. My question is is it possible to run this NEJE A40640 Laser engraver / cutter Module ktis - FAC tech - 2 x laser beam - 10W output laser from blackbox controller PWM output or is impossible? Thank you for your replies
Similar to docs:blackbox:connect-3-wire-laser [OpenBuilds Documentation] except they provide a PSU input, no need to wire PSU to the 3 pin connector
Thank youfor your quick reply. Will pwm have enough power to operate this laser? As it need from pwm 3,3-12V to run.
PWM is a control signal. The controller board on the laser just reads that to know how much power to put into the laser diode. The driverboard takes the power from the power supply, effectively multiplies it by the PWM (Power setting 0-100%) and feeds it to the laser
